TIG Foot Management Cross Reference Tips Guide. This TIG ft management cross reference guidelines shall help you decide which foot extremity can be employed along with your welder

TIG Foot Management Cross Reference Tips Guide. This TIG ft management cross reference guidelines shall help you decide which foot extremity can be employed along with your welder

C810-1425 TIG Foot extremity for Miller RFCS-14 (043554) with 14-Pin Plug

. to ascertain which control works along with your welder, read the many pins on your welder’s rural receptacle (in addition to the shape of the connector) to be sure they complements a plugs below. You could also always check ensure the toes extremity’s model multitude in the owner’s manual meets a model quantity below.

Questions? Contact us at 1-440-205-1600 or send out an email. We are going to help with discovering the TIG welding toes extremity that you want.

You could also look at the TIG Welding leg Pedals webpage to purchase.

When it comes to Miller 330 Aircrafter, SyncroWave 300, SyncroWave 500: check how many pins within the welder’s remote container of these welders, since they may use either the 14-pin or perhaps the 5-pin plug further down.

Hobart: TigMate, Cybertig 180, Cybertig 250, Cybertig 350

Powcon: 300 TSE merely, that a metal reference to a green silicone center. All PowCon begin to see the C880-1425 below.

Thermadyne / Thermal Arc 10-2007 and 10-2008 (like Thermal Arc 400 GTSW because welders using the 14-pin connect which is shown)

Hobart®: Hobart 150 STi

Know: This design is actually all of our regular metal full-sized program with million-cycle rate, including our personal regular industrial-quality potentiometer, metal case, and full-sized walk program, definitely not the light-duty products utilized by Miller® for Diversion walk management. See photograph evaluation: touch to view picture.

CigWeld: W4015800 for your Weldskill 200 AC/DC. Firepower: 1442-0025.

ESAB revolt Program (Rebel EMP 205ic AC/DC, EMP 215ic, EMP 235ic, and EMP 285ic TIG welders) and MINIARC ROGUE Dabei 180I. Changes arch pedal p/n W4014450.

L-TEC / Linde: Heliarc 250 HF.

Go through the plug setting of welder. It has to match the picture proven to the put for this purpose arch pedal to employ the welder. Fortsett å lese «TIG Foot Management Cross Reference Tips Guide. This TIG ft management cross reference guidelines shall help you decide which foot extremity can be employed along with your welder»